Home › TRANSMISSION ยท A343E AUTOMATIC TRANSMISSION › FORWARD CLUTCH

FORWARD CLUTCH > INSPECTION

for Preparation Click here



1. INSPECT PISTON STROKE OF FORWARD CLUTCH


    AT07843E01
  1. Using SST and a dial indicator, measure the forward clutch piston stroke while applying and releasing compressed air (392 to 785 kPa, 4.0 to 8.0 kgf/cm2, 57 to 114 psi).

    SST
    09350-30020   (09350-06120)

    Piston stroke:
    0.6 to 1.0 mm (0.023 to 0.039 in.)

    If the piston stroke is outside the standard, inspect the discs.



2. INSPECT FORWARD MULTIPLE DISC CLUTCH CLUTCH DISC


    AT05820E01
  1. Check to see if the sliding surfaces of the disc, plate and flange are worn or burnt. If necessary, replace them.

    HINT:
    If the lining of the disc is peeling off or discolored, or even if a part of the printed numbers is defaced, replace all discs.



3. INSPECT FRONT CLUTCH PISTON SUB-ASSEMBLY


    AT08170
  1. Check that the check ball is free by shaking the piston.

  1. Check that the valve does not have leaks by applying low-pressure compressed air.



4. INSPECT INPUT SHAFT SUB-ASSEMBLY


    AT08171
  1. Using a dial indicator, measure the inside diameter of the forward clutch drum bushing.

    Maximum inside diameter:
    24.08 mm (0.948 in.)

    If the inside diameter is greater than the maximum, replace the input shaft sub-assembly.