Home › TRANSMISSION ยท A343E AUTOMATIC TRANSMISSION › FORWARD CLUTCH

FORWARD CLUTCH > REASSEMBLY

for Preparation Click here



1. INSTALL INPUT SHAFT OIL SEAL RING


    D025664
  1. Coat the 3 oil seal rings with ATF.

  1. Squeeze the ends of the 3 oil seal rings together with the wrap distance 8 mm (0.31 in.) or less, and then install them to the forward clutch drum groove.

    NOTICE:
    Do not over-spread the ring ends.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.



2. INSTALL FORWARD CLUTCH PISTON O-RING


    D001365E01
  1. Coat 2 new O-rings with ATF and install them on the forward clutch piston.



3. INSTALL FRONT CLUTCH PISTON SUB-ASSEMBLY


    AT08179
  1. Coat new O-ring with ATF, and install them on the forward clutch piston with a screwdriver.



    AT08442
  1. Being careful not to damage the O-rings, and press the clutch piston into the forward clutch drum with both hands.



4. INSTALL FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY


    AT08173
  1. Install the piston return spring.



    Z004543E01
  1. Place SST on the spring retainer, and compress the return spring with a shop press.

    SST
    09350-30020   (09350-07040)

  1. Install the snap ring with SST.

    SST
    09350-30020   (09350-07070)

    NOTICE:
    Be sure the end gap of the snap ring is not aligned with the cutout portion of the forward clutch drum.



5. INSTALL FORWARD MULTIPLE DISC CLUTCH CLUTCH DISC


    AT08177
  1. Install the cushion plate with its rounded end down.



    C116366
  1. Install the 5 plates and discs.

    Install in order:
    P = Plate D = Disc
    P - D - P - D - P - D - P - D -P - D

  1. Install the flange with the rounded edge facing downward.

    HINT:
    There are 8 different thicknesses for the flange.

    Flange thickness: 
    No.
    Thickness
    No.
    Thickness
    61
    3.0 mm (0.118 in.)
    44
    3.8 mm (0.150 in.)
    60
    3.2 mm (0.126 in.)
    42
    4.0 mm (0.157 in.)
    45
    3.4 mm (0.134 in.)
    63
    4.2 mm (0.165 in.)
    62
    3.6 mm (0.142 in.)
    64
    4.4 mm (0.173 in.)



    AT08174
  1. Using a screwdriver, install the snap ring.

    NOTICE:
    Be sure the end gap of the snap ring is not aligned with the cutout portion of the forward clutch drum.



6. INSPECT PISTON STROKE OF FORWARD CLUTCH


    AT07843E01
  1. Using SST and a dial indicator, measure the forward clutch piston stroke while applying and releasing compressed air (392 to 785 kPa, 4.0 to 8.0 kgf/cm2, 57 to 114 psi).

    SST
    09350-30020   (09350-06120)

    Piston stroke:
    0.6 to 1.0 mm (0.023 to 0.039 in.)

    If the piston stroke is outside the standard, inspect the discs.