SECOND BRAKE > DISASSEMBLY |
| 1. REMOVE PLANETARY CARRIER THRUST WASHER NO.4 |
![]() |
Remove the planetary carrier thrust washer No.4.
| 2. INSPECT 2ND BRAKE PISTON |
![]() |
Make sure the 2nd brake piston moves smoothly when applying and releasing low-pressure compressed air to the 2nd brake drum.
| 3. REMOVE 2ND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY |
![]() |
Place SST on the spring retainer, and compress the piston return spring with a press.
Using a snap ring expander, remove the snap ring.
Remove the spring retainer.
![]() |
Remove the piston return spring.
| 4. REMOVE 2ND BRAKE PISTON |
![]() |
Hold the 2nd brake piston by hand, and apply compressed air to the 2nd brake drum to remove the 2nd brake piston.
Remove the 2nd brake piston.
Remove the 2 O-rings from the piston.
| 5. INSPECT 2ND BRAKE CLUTCH DISC |
![]() |
Check if the sliding surfaces of the disc, the plate and flange are worn or burnt. If necessary, replace them.
| 6. INSPECT 2ND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY |
![]() |
Using vernier calipers, measure the free length of the spring together with the spring seat.