REAR PLANETARY GEAR > REASSEMBLY |
| 1. INSTALL REAR PLANETARY RING GEAR FLANGE |
![]() |
Install the ring gear flange.
Using a screwdriver, install the snap ring.
| 2. INSTALL REAR PLANETARY FLANGE THRUST NEEDLE ROLLER BEARING |
![]() |
Coat the races and the bearing with petroleum jelly, and install them onto the rear planetary ring gear.
| Inside | Outside | |
| Race (A) | 28.5 mm (1.122 in.) | 44.2 mm (1.740 in.) |
| Assembled Bearing and Race (B) | 27.7 mm (1.091 in.) | 44.2 mm (1.740 in.) |
| 3. INSTALL PLANETARY CARRIER THRUST WASHER NO.1 |
![]() |
Coat the thrust washer with petroleum jelly.
Install the thrust washer No.1 onto both sides of the rear planetary gear.
| 4. INSTALL PLANETARY CARRIER THRUST WASHER NO.2 |
![]() |
Coat the thrust washer with petroleum jelly.
Install the thrust washer No.2 onto both sides of the rear planetary gear.
| 5. INSTALL 1 WAY CLUTCH NO.2 |
![]() |
Install the one-way clutch and 2 retainers into the rear planetary gear.
![]() |
Using a screwdriver, install the snap ring.
![]() |
While turning the one-way clutch inner race counter clockwise, install the one-way clutch inner race to the rear planetary gear.
| 6. INSPECT 1 WAY CLUTCH NO.2 |
![]() |
Hold the planetary gear and turn the one-way clutch inner race. Check that the one-way clutch inner race can be turned freely counterclockwise and locked clockwise.
| 7. INSTALL REAR PLANETARY RING GEAR |
![]() |
Install the rear planetary gear onto the rear planetary ring gear.
| 8. INSTALL PLANETARY OUTPUT SHAFT OIL SEAL RING |
![]() |
Coat the oil seal ring with ATF, and install it to the output shaft.
| 9. INSTALL REAR PLANETARY GEAR ASSEMBLY |
![]() |
Install the output shaft into the rear planetary gear assembly.