Home › BODY › ENGINE HOOD / DOOR › SLIDE DOOR CLOSER SYSTEM

SLIDE DOOR CLOSER SYSTEM > Door Control Relay Power source Circuit

for Preparation Click here


DESCRIPTION

Power is supplied from the RR DOOR fuse to the door control relay. In order to operate the slide door closer relay.

WIRING DIAGRAM


B111202E01


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (DOOR CONTROL RELAY - BATTERY AND BODY GROUND)


    B111207E01
  1. Disconnect the door control relay.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    LH side:
    Tester Connection
    Condition
    Specified Condition
    B33-3 - Body ground
    Always
    Below 1 Ω
    RH side:
    Tester Connection
    Condition
    Specified Condition
    M2-3 - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    LH side:
    Tester Connection
    Condition
    Specified Condition
    B33-1 - Body ground
    Always
    10 to 14 V
    RH side:
    Tester Connection
    Condition
    Specified Condition
    M2-1 - Body ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROBLEM TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE