Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > Slide Door Lock Motor LH Circuit

for Preparation Click here


DESCRIPTION

The door lock motor is built in the door lock assembly.
The body ECU receives the rear left door lock switch signal from the master switch and operates the door lock motor.

WIRING DIAGRAM


B111178E01


INSPECTION PROCEDURE

1.INSPECT REAR DOOR LOCK ACTUATOR ASSEMBLY LH


    B111185E01
  1. Inspect the slide door lock assembly LH.

  1. Apply battery voltage and check operation of the door lock motor.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Lock
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Unlock



NG
REPLACE REAR DOOR LOCK ACTUATOR ASSEMBLY LH
OK


2.INSPECT SLIDE DOOR CONTROL JUNCTIONFEMALE


    B111186E01
  1. Inspect the slide door control junctionfemale.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A - 1
    Always
    Below 1 Ω
    E - 2
    Always
    Below 1 Ω



NG
REPLACE SLIDE DOOR CONTROL JUNCTIONFEMALE
OK


3.INSPECT SLIDE DOOR CONTROL JUNCTIONMALE


    B102899E01
  1. Inspect the slide door control junctionmale.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A - 2
    Always
    Below 1 Ω
    E - 3
    Always
    Below 1 Ω



NG
REPLACE SLIDE DOOR CONTROL JUNCTIONMALE
OK


4.INSPECT WIRE HARNESS (REAR DOOR LOCK ACTUATOR ASSEMBLY LH - INSTRUMENT PANEL J/B)


    B111187E01
  1. Disconnect the N1 connector.

  1. Disconnect the instrument panel J/B connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    5E-26 - N1-1 (ACT+)
    Always
    Below 1 Ω
    5E-11 - N1-2 (ACT-)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE