POWER DOOR LOCK CONTROL SYSTEM > Slide Door Lock Motor RH Circuit |

| 1.INSPECT REAR DOOR LOCK ACTUATOR ASSEMBLY RH |
![]() |
Inspect the slide door lock assembly RH.
Apply battery voltage and check operation of the door lock motor.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 2 | Lock |
| Battery positive (+) → Terminal 2 Battery negative (-) → Terminal 1 | Unlock |
|
| ||||
| OK | |
| 2.INSPECT SLIDE DOOR CONTROL JUNCTIONFEMALE |
![]() |
Inspect the slide door control junctionfemale.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A - 1 | Always | Below 1 Ω |
| E - 2 | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.INSPECT SLIDE DOOR CONTROL JUNCTIONMALE |
![]() |
Inspect the slide door control junctionmale.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A - 2 | Always | Below 1 Ω |
| E - 3 | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (REAR DOOR LOCK ACTUATOR ASSEMBLY RH - INSTRUMENT PANEL J/B) |
![]() |
Disconnect the M1 connector.
Disconnect the instrument panel J/B connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Condition | Specified Condition |
| 5E-26 - M1-1 (ACT+) | Always | Below 1 Ω |
| 5E-11 - M1-2 (ACT-) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||