Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > Back Door Lock Motor Circuit

for Preparation Click here


DESCRIPTION

The door lock motor is built in the back door lock assembly.
The body ECU receives the driver door switch signal from the master switch and operates the door lock motor.

WIRING DIAGRAM


B111177E04


INSPECTION PROCEDURE

1.INSPECT BACK DOOR REMOTE CONTROL ASSEMBLY


    B111188E01
  1. Inspect the back door remote control assembly.

  1. Apply battery voltage and check operation of the door lock motor.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Unlock
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Lock



NG
REPLACE BACK DOOR REMOTE CONTROL ASSEMBLY
OK


2.CHECK WIRE HARNESS (BACK DOOR REMOTE CONTROL ASSEMBLY - INSTRUMENT PANEL J/B)


    B103322E01
  1. Disconnect the a3 connector.

  1. Disconnect the instrument panel J/B connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    5A-25 - a3-2 (ACT+)
    Always
    Below 1 Ω
    5A-29 - a3-1 (ACT-)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE