ECD SYSTEM > TC and CG Terminal Circuit |

| 1.CHECK DLC3 (CHECK VOLTAGE) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Specified condition |
| BAT (H23-16) - CG (H23-4) | 9 to 14 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (ECM - DLC3) |
![]() |
Disconnect the ECM B10 connector.
Measure the resistance according to the value(s) in the table below
| Tester Connection | Specified Condition |
| SIL (H23-7) - SIL (B10-15) | Below 1 Ω |
| TC (H23-13) - TC (B10-4) | Below 1 Ω |
| Tester Connection | Specified Condition |
| SIL (B10-15) - Body ground | 10 kΩ or higher |
| TC (B10-4) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 3.CHECK DLC3 |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified condition |
| CG (H23-4) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK FUSE (OBD FUSE) |
![]() |
Remove the OBD fuse from the instrument panel J/B.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified condition |
| OBD fuse | Below 1 Ω (continuity) |
|
| ||||
| OK | ||
| ||