CRANKSHAFT POSITION SENSOR > INSTALLATION |
| 1. INSTALL CRANKSHAFT POSITION SENSOR |
![]() |
Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
![]() |
Install the crankshaft position sensor with the bolt.
Connect the 3 wire harness clamps.
![]() |
Connect the crankshaft position sensor connector to the vacuum pipe No.1.
Connect the crankshaft position sensor connector.
| 2. INSTALL VANE PUMP OIL RESERVOIR ASSEMBLY |
![]() |
Install the vane pump oil reservoir assembly with the 2 bolts.
| 3. INSTALL ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1) |