Home › ENGINE ยท 2KD-FTV › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)


2. SEPARATE VANE PUMP OIL RESERVOIR ASSEMBLY


    A102278
  1. Remove the 2 bolts. Separate the vane pump oil reservoir assembly.



3. REMOVE CRANKSHAFT POSITION SENSOR


    A102284
  1. Disconnect the crankshaft position sensor connector.

  1. Separate the connector from the vacuum pipe No.1.



    A102285
  1. Separate the 3 wire harness clamps.

  1. Remove the bolt and the crankshaft position sensor.