Home › ENGINE ยท 2KD-FTV › ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CAMSHAFT POSITION SENSOR


    A102907
  1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.



    A102283
  1. Install the camshaft position sensor with the bolt.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

    NOTICE:
    Be careful that the O-ring is not cracked or jammed when installing the camshaft position sensor.

  1. Connect the camshaft position sensor connector.



2. INSTALL VANE PUMP OIL RESERVOIR ASSEMBLY


    A102278
  1. Install the vane pump oil reservoir assembly with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }