Home › ENGINE ยท 2KD-FTV › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
  1. Install a new gasket onto the engine coolant temperature sensor.

  1. Install the engine coolant temperature sensor.

    Torque:
    20 N*m{ 200 kgf*cm , 14 ft.*lbf }

  1. Connect the engine coolant temperature sensor connector.



2. ADD ENGINE COOLANT
  1. Firmly tighten the drain plugs and fill the radiator reserve tank assembly with coolant to the top of the inlet.

  1. Loosen the bleeder plug of outlet housing.

  1. When air is bled and the coolant drains out, firmly install the bleeder plug.

  1. Add coolant up to the B line mark in the radiator reserve tank assembly and install the radiator cap.

    Coolant capacity:
    Condition
    Capacity
    w/ rear heater
    17.0 liters (18.0 US qts, 15.0 imp. qts)
    w/o rear heater
    15.0 liters (15.9 US qts, 13.2 imp. qts)

  1. Warm up the engine.

  1. After the engine cools down check that the coolant level is between the LOW and FULL level marks.



3. CHECK FOR ENGINE COOLANT LEAKS