Home › ENGINE ยท 2KD-FTV › ENGINE CONTROL SYSTEM › ECM

ECM > INSTALLATION

for Preparation Click here



1. INSTALL ECM


    A113046E02
  1. Install the ECM cover with the 4 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Insert it in securely until it locks 4 ECM connectors.



    A113045E01
  1. Temporarily install the ECM w/ cover to the clamp.

  1. Install the ECM w/ cover with the 2 clips.

    NOTICE:
    Do not use an ECM that was dropped or received strong impact.

  1. Install the floor carpet.



2. INSTALL FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)
  1. Perform the same procedure as above on the opposite side.



3. INSTALL FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)
  1. Perform the same procedure as above on the opposite side.



4. INSTALL FRONT DOOR SCUFF PLATE RH


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. PERFORM INITIALIZATION
(Click here)


7. INSTALL BATTERY SERVICE HOLE COVER (w/ Sub-battery)


8. REGISTER ID CODE
(Click here)


9. CHECK ID CODE
(Click here)


10. INITIALIZE THE LEARNING VALUE OF THE SUPPLY PUMP ASSEMBLY
  1. Perform initialization procedures (Click here).

    NOTICE:
    Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.