Home › ENGINE ยท 2KD-FTV › FUEL › FUEL SYSTEM

FUEL SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK FUEL PRESSURE
  1. READ DATA LIST

    1. Warm up the engine.

    2. Turn the ignition switch off.

    3. Connect the intelligent tester to the DLC3.

    4. Turn the ignition switch on.

    5. Turn the intelligent tester on.

    6. Enter the following menus: Powertrain / ECD / Data List.

    7. Read the Data List.

      Intelligent Tester Display
      Measurement Item/Range (Display)
      Normal Conditions
      Fuel Press
      Fuel pressure/ Min.: 0 MPa, Max.: 655.350 MPa
      25 to 35 MPa: Idling
      Target Common Rail Pressure
      Target common rail pressure/ Min.: 0 kPa, Max.: 655350 kPa
      20 to 160 MPa



2. CHECK FOR FUEL LEAKS
  1. PERFORM ACTIVE TEST

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / ECD / Active Test.

    5. Perform the Active Test.

      Intelligent Tester Display
      Test Details
      Control Range
      Diagnostic Notes
      Test the Fuel Leak
      Pressurizes common rail internal fuel pressure, and checks for fuel leaks
      Stop/Start
      1. Fuel pressure inside common rail pressurized to specified value and engine speed increased to 2,000 rpm when ON is selected
      2. Above conditions preserved while test is ON