FUEL INJECTION NOZZLE > INSPECTION |
| 1. INSPECT NOZZLE HOLDER AND NOZZLE SET |
Pressure test:
![]() |
Install the nozzle holder to the injection nozzle hand tester and bleed air from the union nut.
![]() |
Pump the tester handle a few times as fast as possible to discharge the carbon from the injection hole.
Pump the tester handle slowly and observe the pressure gauge.
Read the pressure gauge just as the injection pressure begins to drop.
| Adjusting shim thickness mm (in.) | ||
| 0.900 (0.0354) 0.956 (0.0374) 1.000 (0.0394) 1.050 (0.0413) 1.100 (0.0433) 1.150 (0.0453) 1.200 (0.0472) 1.250 (0.0492) | 1.300 (0.0512) 1.350 (0.0531) 1.400 (0.0551) 1.450 (0.0571) 1.500 (0.0591) 1.550 (0.0610) 1.600 (0.0630) 1.650 (0.0650) | 1.700 (0.0669) 1.750 (0.0709) 1.800 (0.0728) 1.850 (0.0728) 1.900 (0.0748) 1.950 (0.0768) |
![]() |
Leakage test:
While maintaining pressure at approximately 981 to 1,961 kPa (10 to 20 kgf/cm2, 142 to 284 psi) below injection pressure (adjust by tester handle), check that there is no dripping for 10 seconds from the injection hole or around the retaining nut.
If the nozzle drips within 10 seconds, replace or clean and overhaul the nozzle assembly.
![]() |
Spray pattern test:
The injection nozzle should shudder at a certain pumping speed between 30 and 60 times per minute.
Check the spray pattern during shuddering.
If the spray pattern is not correct during shuddering, the nozzle must be replaced or cleaned.