THROTTLE BODY > INSTALLATION |
| 1. INSTALL THROTTLE BODY ASSEMBLY |
![]() |
Install a new gasket onto the intake manifold.
![]() |
Install the throttle body assembly with the 2 bolts and 2 nuts. (A)
Connect the water by-pass hose. (B)
Connect the water by-pass hose No.2. (C)
Connect the throttle motor connector. (D)
| 2. INSTALL INTAKE AIR CONNECTOR |
Temporarily install the intake air connector to the throttle body assembly.
![]() |
Connect the ventilation hose No.2 and the vacuum hose. (A)
Install the intake air connector with the 2 bolts. (B)
Tighten the 2 hose clamp bolts. (C)
Tighten the 2 hose clamp bolts. (D)
| 3. ADD ENGINE COOLANT |
Firmly tighten the drain plugs and fill the reservoir tank with coolant to the top of the inlet.
Remove the 2-way that is located near the throttle body.
When air is bled and the coolant drains out, firmly install the 2-way.
Add coolant up to the B line mark in the reservoir tank and install the radiator cap.
| Condition | Capacity |
| w/ rear heater | 15.0 liters (15.8 US qts, 13.2 lmp. qts) |
| w/o rear heater | 13.0 liters (13.7 US qts, 11.4 lmp. qts) |
Warm up the engine.
After the engine cools down, check that the coolant level is between the LOW and FULL level marks.
| 4. INSTALL ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY |
Install the engine service hole sub cover with the 5 bolts.
| 5. INSTALL FRONT DOOR SCUFF PLATE RH |
| 6. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type) |
| 7. INSTALL FRONT SEAT ASSEMBLY RH (for Low-back Seat Type) |
| 8. INSTALL ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1) |
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 10. INSPECT THROTTLE BODY ASSEMBLY |
| 11. REMOVE PERFORM INITIALIZATION |