Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › ECM

ECM > INSTALLATION

for Preparation Click here



1. INSTALL ECM


    A113046E02
  1. Install the ECM cover with the 4 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Insert the ECM w/ cover in securely until it locks 4 ECM connectors.



    A113045E01
  1. Temporarily install the ECM w/ cover to the clamp.

  1. Install the ECM w/ cover with the 2 clips.

    NOTICE:
    Do not reuse an ECM that was dropped or that received strong impact.

  1. Install the floor carpet.



2. INSTALL FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)
  1. Perform the same procedure as above on the opposite side.



3. INSTALL FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)
  1. Perform the same procedure as above on the opposite side.



4. INSTALL FRONT DOOR SCUFF PLATE RH


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. PERFORM INITIALIZATION
  1. Perform initialization procedures (Click here).

    NOTICE:
    Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.