ENGINE > ON-VEHICLE INSPECTION |
| 1. INSPECT ENGINE COOLANT |
Remove the radiator cap.
Check if there is any excessive deposits of rust or scale around the radiator cap and radiator filler hole. The coolant should be free from oil.
Install the radiator cap.
| 2. INSPECT ENGINE OIL |
Warm up the engine, stop the engine and wait for 5 minutes. The oil level should be between the low and full level marks of the dipstick.
If low, check for leakage and add oil up to the full level mark.
| 3. INSPECT BATTERY |
Check the battery for damage and deformation. If severe damage, deformation, or leakage is found, replace the battery.
Check the electrolyte level of each cell.
For maintenance-free batteries:
For non-maintenance-free batteries:
| 4. INSPECT AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
Remove the air cleaner filter element from the air cleaner case.
Visually check that there no dirt, clog, and damage to the air cleaner filter element.
| 5. CHECK IDLE SPEED |
Connect the intelligent tester to the DLC3.
![]() |
If the tester is not available, connect a tester probe of a tachometer to terminal 9 (TAC) of the DLC3 with SST.
Start the engine and check the idle speed.
In case of the tester probe of the tachometer is connected to the DLC3, disconnect the tester probe from terminal 9 of the DLC3 with SST.
Disconnect the intelligent tester from the DLC3.
| 6. INSPECT MAXIMUM ENGINE SPEED |
Connect the intelligent tester to the DLC3.
![]() |
If the tester is not available, connect a tester probe of a tachometer to terminal 9 (TAC) of the DLC3 with SST.
Start the engine.
Depress the accelerator pedal all the way to the limit.
Check the maximum speed.
In case of the tester probe of the tachometer is connected to the DLC3, disconnect the tester probe from terminal 9 of the DLC3 with SST.
Disconnect the intelligent tester from the DLC3.
| 7. INSPECT COMPRESSION PRESSURE |
Remove all the 4 glow plug assemblies.
Disconnect all the connectors from the 4 injectors.
Evacuate extraneous stuff such as soot in the cylinder by turning the starter.
![]() |
Set SST (attachment) into the glow plug hole.
Measure the compression pressure while cranking the engine.
Repeat steps (d) and (e) for each cylinder.
Remove the SST (attachment and compression gauge).
Connect all the connectors to the 4 injectors.
Install all the 4 glow plug assemblies.