Home › ENGINE ยท 2KD-FTV › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > INSPECTION

for Preparation Click here



1. INSPECT FAN AND GENERATOR V BELT


    A114818E01
  1. Visually check the belt for excessive wear, frayed cords, etc. If any defect has been found, replace the belt.

    HINT:
    1. Cracks on the rib side of a belt are considered acceptable. If the belt has chunks missing from the ribs, it should be replaced.
    2. After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Check that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.
    3. A "new belt" is a belt which has been used for less than 5 minutes with the engine running.
    4. A "used belt" is a belt which has been used for 5 minutes with the engine running.
    5. After installing a new belt, run the engine for approximately 5 minutes and then recheck the tension.



2. INSPECT V-RIBBED BELT TENSIONER ASSEMBLY
  1. Check that nothing gets caught in the tensioner by turning it clockwise and counterclockwise. If a malfunction exitsts, replace the tensioner.