Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY

FRONT SEAT INNER BELT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEAT INNER BELT ASSEMBLY (for Separate Seat Type)


    B107658
  1. Install the front seat inner belt assembly with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



    B107656
  1. for Driver side:

    1. Install the 3 clamps.



    B107657
  1. for Passenger side:

    1. Install the 5 clamps.

    2. Connect the connector.



2. INSTALL FRONT SEAT CUSHION SHIELD INNER LH (for Separate Seat Type)


3. INSTALL FRONT SEAT ASSEMBLY (for Separate Seat Type)
for Hi-back seat type
for Low-back seat type


4. INSTALL FRONT SEAT INNER BELT ASSEMBLY (for Split Bench Seat Type)


    B101656
  1. Install the front seat inner belt assembly with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. w/ Seat belt warning:

    1. Connect the connector.



5. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD (for Split Bench Seat Type)


    B101687E01
  1. w/o Seat belt warning occupant detection sensor:

    1. Install the separate type front seat cushion cover with pad with the 2 bolts.

      Torque:
      39 N*m{ 398 kgf*cm , 29 ft.*lbf }

      NOTICE:
      1. Make sure that the wire frame of the separate type front seat cushion cover is completely engaged.
      2. Tighten the bolts in the following order.
      3. Temporarily tighten bolt (2).
      4. Fully tighten bolt (1).
      5. Fully tighten bolt (2).



    B103882E01
  1. w/ Seat belt warning occupant detection sensor:

    1. Connect the connector.

    2. Install the separate type front seat cushion cover with pad with the 2 bolts.

      Torque:
      39 N*m{ 398 kgf*cm , 29 ft.*lbf }

      NOTICE:
      1. Make sure that the wire frame of the separate type front seat cushion cover is completely engaged.
      2. Tighten the bolts in the following order.
      3. Temporarily tighten bolt (2).
      4. Fully tighten bolt (1).
      5. Fully tighten bolt (2).