Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Air Conditioning Amplifier Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
Air Conditioning Amplifier Communication Stop Mode
"A/C" is not displayed on the "Communication Bus Check" screen of the intelligent tester.
  1. Power source or inside the air conditioning amplifier
  2. Air conditioning amplifier sub bus line or connector

WIRING DIAGRAM


C107864E02


INSPECTION PROCEDURE

1.CHECK CAN BUS LINE FOR DISCONNECTION (AIR CONDITIONING AMPLIFIER SUB BUS LINE)


    C107863E02
  1. Turn the ignition switch to the LOCK position.

  1. Disconnect the air conditioning amplifier connector (H18).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    H18-10 (CANH) -
    H18-11 (CANL)
    IG switch OFF
    54 to 69 Ω



NG
REPAIR OR REPLACE AIR CONDITIONING AMPLIFIER SUB BUS LINE OR CONNECTOR (CANH, CANL)
OK


2.CHECK WIRE HARNESS (IG, GND)


    C107863E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    H18-29 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Value
    H18-20 (IG+) - Body ground
    IG switch ON
    10 to 14 V



NG
REPAIR OR REPLACE WIRE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER