Home › ENGINE ยท 5L-E › ENGINE MECHANICAL › ENGINE REAR OIL SEAL

ENGINE REAR OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE REAR OIL SEAL


    A057268E02
  1. Apply MP grease to a new oil seal lip.

    NOTICE:
    Keep the lip free from foreign matter.

  1. Using SST, tap in the oil seal until its surface is flush with the engine rear oil seal retainer edge.

    SST
    09223-15030  
    09950-70010   (09951-07100)

    NOTICE:
    Wipe off extra grease on the crankshaft.



2. INSTALL FLYWHEEL HOUSING DUST SEAL
  1. Install the flywheel housing dust seal.



3. INSTALL REAR END PLATE
  1. Install the 2 bolts and rear end plate.

    Torque:
    27 N*m{ 275 kgf*cm , 19 ft.*lbf }



4. INSTALL FLYWHEEL SUB-ASSEMBLY


    A058716E01
  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. Clean the bolts and bolt holes.

  1. Apply adhesive to 2 or 3 threads of the bolts.

    Adhesive:
    Part No.08833-00070, THREE BOND 1324 or equivalent

  1. Install the flywheel on the crankshaft.



    A058717E01
  1. Install and uniformly tighten the 8 bolts in several steps, in the sequence shown.

    Torque:
    123 N*m{ 1,250 kgf*cm , 90 ft.*lbf }

    NOTICE:
    Do not start the engine within an hour after installing.



5. INSTALL CLUTCH DISC ASSEMBLY


    C104158E01
  1. Insert SST into the clutch disc assembly, then insert them into the flywheel sub-assembly.

    SST
    09301-00110  

    NOTICE:
    Take care not to insert the clutch disc assembly in the wrong direction.



6. INSTALL CLUTCH COVER ASSEMBLY


    C114265E02
  1. Align the matchmarks on the clutch cover assembly with the one on the flywheel sub-assembly.

  1. Following the procedures shown in the illustration, tighten the 6 bolts starting from the bolt located near the knock pin on the top.

    SST
    09301-00110  

    Torque:
    19 N*m{ 195 kgf*cm , 14 ft.*lbf }

    HINT:
    1. Evenly tighten the bolts by following the order shown in the illustration.
    2. Tighten the bolts after checking that the disc is in the center by lightly moving the SST up and down, left and right.



7. INSTALL MANUAL TRANSMISSION ASSEMBLY
(Click here)