Home › ENGINE ยท 5L-E › ENGINE MECHANICAL › ENGINE REAR OIL SEAL

ENGINE REAR OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE MANUAL TRANSMISSION ASSEMBLY
(Click here)


2. REMOVE CLUTCH COVER ASSEMBLY


    C114267E01
  1. Put matchmarks on the clutch cover assembly and the flywheel sub-assembly.

  1. Loosen each set bolt one turn at a time until spring tension is released.

    NOTICE:
    Do not drop the clutch disc assembly.

  1. Remove the set bolts, and pull off the clutch cover assembly.



3. REMOVE CLUTCH DISC ASSEMBLY

NOTICE:
Keep the lining part of the clutch disc assembly, the pressure plate and surface of the flywheel sub-assembly away from oil and foreign matter.



4. REMOVE FLYWHEEL SUB-ASSEMBLY


    A058716E01
  1. Fix the crankshaft with SST, then remove the 8 bolts and flywheel.

    SST
    09213-54015   (91651-60855)
    09330-00021  



5. REMOVE REAR END PLATE
  1. Remove the 2 bolts and rear end plate.



6. REMOVE FLYWHEEL HOUSING DUST SEAL
  1. Remove the flywheel housing dust seal.



7. REMOVE ENGINE REAR OIL SEAL


    A057267E02
  1. Using a knife, cut off the oil seal lip.

  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    After the removal, check that the crankshaft is not damaged. If damaged, mend it with a sandpaper (#400).