Home › ENGINE ยท 5L-E › ENGINE MECHANICAL › CAMSHAFT

CAMSHAFT > REMOVAL

for Preparation Click here



1. REMOVE TIMING BELT
(Click here)


2. SEPARATE AIR CLEANER HOSE NO.2
  1. Loosen the bolt, and disconnect the air cleaner hose No.2.



3. REMOVE INTAKE AIR CONNECTOR SUB-ASSEMBLY
  1. Disconnect the ventilation hose.

  1. Disconnect the turbo pressure sensor connector.



    A111051
  1. Remove the bolt, 3 nuts, intake air connector and gasket.



4. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
  1. Disconnect the ventilation hose.

  1. Remove the 9 bolts, nut, cylinder head cover and gasket.



5. REMOVE CAMSHAFT TIMING PULLEY


    A057443E02
  1. Set the No.1 cylinder to approx. 90° BTDC/compression.

    HINT:
    Set the No.1 cylinder to 90° BTDC/compression to avoid interference with the piston top and valve head.


    1. Using the crankshaft pulley bolt, turn the crankshaft 90° counterclockwise, and put the timing mark of the crankshaft timing pulley with the protrusion of the timing gear case.



    A056901E02
  1. Using SST, loosen the pulley bolt.

    SST
    09960-10010   (09962-01000, 09963-01000)



    A056903E02
  1. Using SST, separate the timing pulley from the camshaft.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05010, 09954-05021)

  1. Remove the pulley bolt and timing pulley.

  1. Remove the timing gear woodruff key.



6. REMOVE TIMING BELT NO.2 COVER
  1. Remove the 4 bolts and timing belt cover.



7. REMOVE CAMSHAFT OIL SEAL RETAINER
  1. Remove the 4 bolts, retainer and gasket.



8. REMOVE OIL SEAL RETAINER, NO.2 OIL SEAL


    A057634E01
  1. Using a screwdriver and hammer, tap out the oil seal.



9. REMOVE CAMSHAFT


    A057786E02
  1. Turn the camshaft with a wrench so that the key groove faces upward.



    A057787E04
  1. Uniformly loosen and remove the 10 bearing cap bolts, in several steps, in the sequence shown.

  1. Remove the 5 bearing caps and camshaft.