Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › CLEARANCE SONAR SYSTEM

CLEARANCE SONAR SYSTEM > Rear Clearance Sonar Sensor RH Circuit


DESCRIPTION

An ultrasonic sensor consists of a sensor portion that transmits and receives ultrasonic waves and a pre-amplifier that amplifies them. The ultrasonic sensor outputs the ultrasonic transmission and reception signals to the clearance warning ECU.

WIRING DIAGRAM


E110859E06


INSPECTION PROCEDURE

1.INSPECT NO.1 ULTRASONIC SENSOR


    I041795E02
  1. Remove No.1 ultrasonic sensor.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    Condition
    Specified condition
    1 - 2
    Always
    900 +- 300 kΩ



NG
REPLACE NO.1 ULTRASONIC SENSOR
OK


2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - NO.1 ULTRASONIC SENSOR)


    E111339E07
  1. Disconnect the H33 connector from the clearance warning ECU.



    I041776E06
  1. Disconnect the W4 connector from the No.1 ultrasonic sensor.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    (Symbols)
    Condition
    Specified condition
    H33-3 (S5) - W4-2 (S)
    Always
    Below 1 Ω
    H33-16 (E5) - W4-1 (E)
    Always
    Below 1 Ω
    H33-3 (S5) -
    Body ground
    Always
    10 kΩ or higher
    H33-16 (E5) -
    Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

RETURN TO THE ORIGINAL INSPECTION FLOW BECAUSE THE CHECK RESULT IS NORMAL