Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › CLEARANCE SONAR SYSTEM

CLEARANCE SONAR SYSTEM > Indicator Circuit


DESCRIPTION

The indicator displays the location of the obstacle and the approximate distance between the vehicle and the obstacle either by blinking or turning on.

WIRING DIAGRAM


E110863E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - CLEARANCE WARNING INDICATOR)


    E111341E02
  1. Disconnect the H33 connector from the clearance warning ECU.

  1. Disconnect the H15 connector from the clearance warning indicator.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    (Symbols)
    Condition
    Specified condition
    H15-10 (OP) -
    H33-30 (L10)
    Always
    Below 1 Ω
    H15-9 (BK) - H33-11 (L7)
    Always
    Below 1 Ω
    H15-5 (FL) - H33-31 (L4)
    Always
    Below 1 Ω
    H15-4 (RL) - H33-12 (L6)
    Always
    Below 1 Ω
    H15-3 (FR) - H33-32 (L1)
    Always
    Below 1 Ω
    H15-2 (RR) - H33-13 (L5)
    Always
    Below 1 Ω
    H15-10 (OP) -
    Body ground
    Always
    10 kΩ or higher
    H15-9 (BK) -
    Body ground
    Always
    10 kΩ or higher
    H15-5 (FL) -
    Body ground
    Always
    10 kΩ or higher
    H15-4 (RL) -
    Body ground
    Always
    10 kΩ or higher
    H15-3 (FR) -
    Body ground
    Always
    10 kΩ or higher
    H15-2 (RR) -
    Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

RETURN TO THE ORIGINAL INSPECTION FLOW BECAUSE THE CHECK RESULT IS NORMAL