Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › CLEARANCE SONAR SYSTEM

CLEARANCE SONAR SYSTEM > Speed Signal Circuit


DESCRIPTION

The clearance warning ECU receives the vehicle speed signal from the combination meter.

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter. The signal is changed to a pulse signal at the transistor in the combination meter. Each ECU controls the respective system based on the pulse signal.
  2. If a short occurs in an ECU, all systems in the diagram below will not operate normally.


WIRING DIAGRAM


E110854E01


INSPECTION PROCEDURE

1.CHECK OPERATION OF SPEEDOMETER
  1. Drive the vehicle and check if the function of the speedometer in the combination meter is normal.

    OK:
    Actual vehicle speed and the speed indicated on the speedometer are the same.

    HINT:
    The vehicle speed sensor is functioning normally when the indication on the speedometer is normal.



NG
CHECK COMBINATION METER
OK


2.INSPECT CLEARANCE WARNING ECU


    E112077E01
  1. Disconnect the clearance warning ECU connector H33.



  1. Measure voltage.

    1. Jack up either one of the drive wheels.

    2. Move the shift lever to the neutral position.

    3. Turn the ignition switch to the ON position.



    4. E110855E01
    5. Measure the voltage between terminal SPD of the clearance warning ECU and body ground when the drive wheels are turned slowly.

      OK:
      Voltage pulses as shown.



OK
REPLACE CLEARANCE WARNING ECU
NG


3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - CLEARANCE WARNING ECU)


    E111338E01
  1. Disconnect the combination meter H20 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    (Symbols)
    Condition
    Specified condition
    H33-25 (SPD) -
    H20-9 (+S)
    Ignition switch off
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (COMBINATION METER AND EACH ECU - BODY GROUND)


    E111339E01
  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    (Symbols)
    Condition
    Specified condition
    H33-25 (SPD) -
    Body ground
    Ignition switch off
    10 kΩ or higher

    HINT:
    If the resistance between terminal SPD and body ground is less than 10 kΩ, there may be a short in a wire harness, connector, or ECU.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR OR CHECK EACH ECU
OK

REPLACE COMBINATION METER