Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › CLEARANCE SONAR SYSTEM

CLEARANCE SONAR SYSTEM > Reverse Signal Circuit


DESCRIPTION

The clearance warning ECU receives the reverse signal from the back-up light switch (M/T) or park/neutral position switch (A/T).

WIRING DIAGRAM


E110856E01


INSPECTION PROCEDURE

1.INSPECT CLEARANCE WARNING ECU


    E112077E02
  1. Disconnect the H33 connector from the clearance warning ECU.

  1. Measure the voltage according to the value(s) in the table below.

    Voltage:
    Tester connection
    (Symbols)
    Condition
    Specified condition
    H33-9 (RL) -
    Body ground
    Ignition switch ON, shift lever R position
    10 to 14 V



OK
RETURN TO THE ORIGINAL INSPECTION FLOW BECAUSE THE CHECK RESULT IS NORMAL
NG


2.CHECK HARNESS AND CONNECTOR


    E111340E01
  1. Disconnect the connector from the back-up light switch (M/T) or park/neutral position switch (A/T).

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    (Symbols)
    Condition
    Specified condition
    H33-9 (RL) - D37-1 (*1)
    Always
    Below 1 Ω
    H33-9 (RL) - D36-1 (*2)
    Always
    Below 1 Ω
    H33-9 (RL) -
    Body ground
    Always
    10 kΩ or higher

    *1: A/T
    *2: M/T



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK TYPE
  1. Choose type to be inspected.

    Result:

    Type
    Go to step
    A/T
    A
    M/T
    B



B
Go to step 5
A


4.INSPECT PARK/NEUTRAL POSITION SWITCH


    E110857E01
  1. Disconnect the park/neutral position switch connector D37.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    Condition
    Specified condition
    D37-1 - D37-2
    Shift lever is moved to R position.
    Below 1 Ω
    D37-1 - D37-2
    Shift lever is moved to any position except R.
    10 kΩ or higher



NG
REPLACE PARK/NEUTRAL POSITION SWITCH
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR 

5.INSPECT BACK UP LIGHT SWITCH


    I045225E01
  1. Disconnect the back-up light switch connector D36.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    Condition
    Specified condition
    D36-1 - D36-2
    Shift lever is moved to R position.
    Below 1 Ω
    D36-1 - D36-2
    Shift lever is moved to any position except R.
    10 kΩ or higher



NG
REPLACE BACK UP LIGHT SWITCH
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR