Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › CLEARANCE SONAR SYSTEM

CLEARANCE SONAR SYSTEM > OPERATION CHECK



DETECTION RANGE MEASUREMENT AND INDICATOR CHECK
  1. Turn the ignition switch to the ON position.

  2. Move the shift lever to the R position.

    NOTICE:
    Apply the parking brake securely so that the vehicle does not move.

  3. Turn the clearance sonar main switch on.



  4. Move a φ 60 mm (2.36 in.) pole around the sensors to measure the detection ranges of the sensors.


    E111275E01

    NOTICE:
    The measured detection ranges are for a φ 60 mm (2.36 in.) pole. The detection ranges for walls and other obstacles are different.



  5. Check the indicator and the buzzer sounding condition when the back sonar sensors detect an obstacle.


    E110849E01


    Operation condition:

    Ignition switch
    Clearance sonar main switch
    Shift position
    Vehicle speed
    ON
    ON
    R position
    10 km/h (6 mph) or less

    HINT:
    Since sound waves are used for the detection range measurement, the detection ranges may vary a little due to the outside air temperature.



  6. Check the indicator and the buzzer sounding condition when the rear clearance sonar sensors detect an obstacle.


    E110850E01


    Operation condition:

    Ignition switch
    Clearance sonar main switch
    Shift position
    Vehicle speed
    ON
    ON
    R position
    10 km/h (6 mph) or less

    HINT:
    Since sound waves are used for the detection range measurement, the detection ranges may vary a little due to the outside air temperature.



  7. Check the indicator and the buzzer sounding condition when the front clearance sonar sensors detect an obstacle.


    E110851E01


    Operation condition (A/T):

    Ignition switch
    Clearance sonar main switch
    Shift position
    Vehicle speed
    ON
    ON
    Except P position
    10 km/h (6 mph) or less


    Operation condition (M/T):

    Ignition switch
    Clearance sonar main switch
    Shift position
    Vehicle speed
    ON
    ON
    Always
    10 km/h (6 mph) or less

    HINT:
    Since sound waves are used for the detection range measurement, the detection ranges may vary a little due to the outside air temperature.


CHECK INITIAL CHECK FUNCTION


    E111283E01
  1. Turn the ignition switch to the ON position.

  2. Move the shift lever to the R position.



  3. Turn the back and clearance sonar main switch on and check the indicators (LEDs) and buzzer conditions.


    E110852E01

    Standard:
    Approximately 0.1 seconds after the main switch is turned on, all the LEDs come on and the buzzer sounds for approximately 0.8 +- 0.3 seconds. Then the back and clearance sonar sensors switch to detection mode.

    HINT:
    1. If the system detects an open circuit in any sensor circuit, or any sensor does not work (unable to detect because the sensor is wet or frozen), the LEDs and buzzer operate as shown in the illustration below.
    2. If the clearance sonar sensor circuits return to normal, the clearance sonar sensors will automatically return to normal operation.
    3. If the back sonar sensor circuits return to normal, the back sonar sensors will return to normal operation after the ignition switch is first turned off and then on again.