Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › CLEARANCE SONAR SYSTEM

CLEARANCE SONAR SYSTEM > Dimmer Signal Circuit


DESCRIPTION

The taillight relay turns on when the light control switch is turned to the "TAIL" or "HEAD" position. The clearance warning ECU dims the clearance sonar display when it receives a tail relay ON signal.

WIRING DIAGRAM


E110858E01


INSPECTION PROCEDURE

1.INSPECT CLEARANCE WARNING ECU


    E112077E03
  1. Disconnect the clearance warning ECU H33 connector.

  1. Measure the voltage according to the value(s) in the table below.

    Voltage:
    Tester connection
    (Symbols)
    Condition
    Specified condition
    H33-26 (TL) -
    Body ground
    Light control switch "TAIL" or "HEAD" position
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

RETURN TO THE ORIGINAL INSPECTION FLOW BECAUSE THE CHECK RESULT IS NORMAL