CLEARANCE SONAR SYSTEM > Clearance Sonar Main Switch Circuit |

| 1.INSPECT CLEARANCE WARNING ECU |
![]() |
Disconnect the H33 connector from the clearance warning ECU.
Measure the voltage according to the value(s) in the table below.
| Tester connection (Symbols) | Condition | Specified condition |
| H33-8 (IG) - H33-27 (E) |
| 10 to 14 V |
|
| ||||
| NG | |
| 2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester connection (Symbols) | Condition | Specified condition |
| H33-27 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.INSPECT CLEARANCE WARNING INDICATOR |
![]() |
Remove the clearance warning indicator.
Disconnect the H15 connector from the clearance warning indicator.
Measure the voltage according to the value(s) in the table below.
| Tester connection (Symbols) | Condition | Specified condition |
| H15-7 (BD) - Body ground | Ignition switch ON | 10 to 14 V |
|
| ||||
| OK | |
| 4.INSPECT CLEARANCE WARNING INDICATOR |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester connection (Symbols) | Condition | Specified condition |
| H15-7 (BD) - H15-12 (SK) | Clearance sonar main switch OFF | 10 kΩ or higher |
| H15-7 (BD) - H15-12 (SK) | Clearance sonar main switch ON | Below 1 Ω |
|
| ||||
| OK | ||
| ||