Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › CLEARANCE SONAR SYSTEM

CLEARANCE SONAR SYSTEM > Clearance Warning Buzzer Circuit


DESCRIPTION

The clearance warning ECU receives the ultrasonic sensor signal to sound the clearance warning buzzer.

WIRING DIAGRAM


E110862E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - CLEARANCE WARNING INDICATOR)


    E111341E01
  1. Disconnect the connectors from the clearance warning ECU H33 and clearance warning indicator H15.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    (Symbols)
    Condition
    Specified condition
    H33-10 (CBZ) -
    H15-11 (BZ)
    Always
    Below 1 Ω
    H33-10 (CBZ) -
    Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

RETURN TO THE ORIGINAL INSPECTION FLOW BECAUSE THE CHECK RESULT IS NORMAL