Home › ENGINE · 5L-E › ENGINE CONTROL SYSTEM › VENTURI

VENTURI > INSPECTION

for Preparation Click here



1. INSPECT VENTURI ASSEMBLY


  1. Resistance inspection. (Throttle control motor)



      A031135
    1. Using an ohmmeter, measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Terminals
      Temperature
      Resistance
      2 - 1, 3
      at 20°C (68°F)
      18 to 22 Ω
      5 - 4, 6
      at 20°C (68°F)
      18 to 22 Ω



  1. Continuity inspection. (Throttle valve switch)



      A072560
    1. Using an ohmmeter, measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Throttle valve
      Resistance
      Fully open
      Below 1 Ω
      Fully close
      10 KΩ or higher