VENTURI > REMOVAL |
| 1. SEPARATE CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. SEPARATE AIR CLEANER HOSE NO.2 |
Loosen the bolt, and disconnect the air cleaner hose No.2.
| 3. REMOVE INTAKE AIR CONNECTOR SUB-ASSEMBLY |
Disconnect the ventilation hose.
Disconnect the turbo pressure sensor connector.
![]() |
Remove the bolt, 3 nuts, intake air connector and gasket.
| 4. REMOVE VENTURI ASSEMBLY |
![]() |
Disconnect the throttle open switch connector.
![]() |
Disconnect the throttle control motor connector.
Remove the venturi and gasket.