Home › ENGINE · 5L-E › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT WATER TEMPERATURE SENSOR


    Z017274E12
  1. Resistance inspection.

    1. Using an ohmmeter, measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Temperature
      Resistance
      at 20°C (68°F)
      2.32 to 2.59 kΩ
      at 80°C (176°F)
      0.310 to 0.326 kΩ

      NOTICE:
      In case of checking the water temperature sensor in the water, be careful not to allow water to go into the terminals, and after checking, wipe out the sensor.