Home › ENGINE ยท 5L-E › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL WATER TEMPERATURE SENSOR


    A111055E01
  1. Install a new gasket and water temperature sensor with the bolt.

    Torque:
    20 N*m{ 200 kgf*cm , 14 ft.*lbf }

  1. Connect the water temperature sensor connector.



2. ADD ENGINE COOLANT
  1. Close the engine drain plug.

    Torque:
    57 N*m{ 581 kgf*cm , 42 ft.*lbf }

  1. Close the radiator drain cock plug.

  1. Slowly fill the cooling system with coolant.

    HINT:
    The coolant level inside the radiator should be abserved after pressing the radiator hose inlet and radiator hose outlet by hand..

  1. Slowly pour coolant into the radiator reserve tank until it reaches the FULL line.

  1. Install the radiator cap to the radiator reserve tank.

  1. Press the inlet and outlet radiator hoses several times by hand while warming up the engine.

  1. Stop the engine, and wait until the engine coolant cools down.

  1. Add coolant to the FULL line of the radiator reservoir.



3. CHECK FOR ENGINE COOLANT LEAKS