Home › ENGINE · 2TR-FE › ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSPECTION

for Preparation Click here



1. INSPECT CAMSHAFT POSITION SENSOR


    A088648E01
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 (G+) - 2 (G-)
      950 to 1,250 Ω at 20°C (68°F)

      If the result is not as specified, replace the camshaft position sensor.