Home › ENGINE · 2TR-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSPECTION

for Preparation Click here



1. INSPECT CRANKSHAFT POSITION SENSOR


    A074841
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 (NE+) - 2 (NE-)
      1,850 to 2,450 Ω at 20°C (68°F)

      If the result is not as specified, replace the crankshaft position sensor.