CRANKSHAFT POSITION SENSOR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1 and Air Conditioning) |
| 3. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type, w/ Air Conditioning) |
| 4. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type, w/ Air Conditioning) |
| 5. REMOVE FRONT DOOR SCUFF PLATE RH (w/ Air Conditioning) |
| 6. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY (w/ Air Conditioning) |
Roll up the carpet, and remove the 5 bolts and engine service hole sub cover.
| 7. REMOVE OIL LEVEL GAUGE GUIDE (w/ Air Conditioning) |
![]() |
Remove the bolt and gauge guide.
| 8. REMOVE FAN AND GENERATOR V BELT (w/ Air Conditioning) |
![]() |
Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the drive belt. Then remove the drive belt.
| 9. SEPARATE COMPRESSOR AND MAGNETIC CLUTCH (w/ Air Conditioning) |
Disconnect the compressor connector.
![]() |
Remove the 4 bolts and disconnect the compressor from the engine.
Support the cooler compressor securely.
| 10. REMOVE COMPRESSOR MOUNTING BRACKET NO.1 (w/ Air Conditioning) |
![]() |
Remove the 5 bolts and compressor mounting bracket.
| 11. REMOVE CRANKSHAFT POSITION SENSOR |
![]() |
Disconnect the crankshaft position sensor connector and the 2 wire harness clamps.
![]() |
Remove the bolt and crankshaft position sensor.