ELECTRONIC CONTROLLED AUTOMATIC TRANSMISSION SYSTEM > HYDRAULIC TEST |
| PERFORM HYDRAULIC TEST |
Measure the line pressure.
![]() |
Warm up the ATF (Automatic Transmission Fluid).
Lift the vehicle up.
Remove the test plug on the transmission case front left side and connect SST.
Fully apply the parking brake and chock the 4 wheels.
Start the engine and check idling speed.
Keep your left foot pressing firmly on the brake pedal and shift into the D position.
Measure the line pressure when the engine is idling.
Depress the accelerator pedal all the way down. Quickly read the highest line pressure when engine speed reaches stall speed.
In the same manner, do the test in the R position.
| Condition | D position kPa (kgf / cm2, psi) | R position kPa (kgf / cm2, psi) |
| Idling | 318 - 377 kPa (3.2 - 3.8 kgf/cm2, 46 - 55 psi) | 559 - 673 kPa (5.7 - 6.9 kgf/cm2, 81 - 98 psi) |
| Stall test | 1,011 - 1,135 kPa (10 - 12 kgf/cm2, 147 - 165 psi) | 1,293 - 1,571 kPa (13 - 16 kgf/cm2, 188 - 228 psi) |
| Problem | Possible cause |
| Measured values are higher than specified in all positions |
|
| Measured values are lower than specified in all positions |
|
| Pressure is low in the D position only |
|
| Pressure is low in the R position only |
|