WIRELESS DOOR LOCK CONTROL SYSTEM > DTC CHECK / CLEAR |
| SELF DIAGNOSTIC MODE |
Change to the self-diagnostic mode.
Close the driver side door and ensure that the door lock knob is in the UNLOCK position.
Insert the key into the ignition key cylinder and remove it.
Within 5 seconds after the key is removed, insert it into the ignition key cylinder again.
Turn the ignition switch to the ON position and then off.
Within 30 seconds of turning the ignition switch off, turn the ignition switch to the ON position then off 9 times.
![]() |
Check that the system has changed to self-diagnostic mode by checking the door lock operation (LOCK → UNLOCK) as shown in the illustration.
![]() |
Check the diagnostic outputs when the door control transmitter switch is held down. The diagnostic outputs can be checked by the door lock operating patterns shown in the illustration.