Home › BODY ELECTRICAL › DOOR LOCK › DOOR CONTROL SWITCH

DOOR CONTROL SWITCH > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (W/ POWER WINDOW)


    B050518E01
  1. Disconnect the power window master switch assembly.

  1. Measure the resistance when the switch is operated according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Door Lock Condition
    Specified Condition
    1 - 8
    ON (Door lock set to UNLOCK)
    Below 1 Ω
    1 - 5
    OFF (Door Lock set to LOCK)
    Below 1 Ω



2. INSPECT DOOR CONTROL SWITCH ASSEMBLY (W/O POWER WINDOW)


    E101530E02
  1. Disconnect the door control switch assembly.

  1. Measure the resistance when the switch is operated according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Door Lock Condition
    Specified Condition
    5 - 6
    ON (Door lock set to UNLOCK)
    Below 1 Ω
    3 - 6
    OFF (Door Lock set to LOCK)
    Below 1 Ω