Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL ROD

ACCELERATOR PEDAL ROD > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ACCELERATOR PEDAL ROD ASSEMBLY


  1. Inspect the voltage.



      A082779E16
    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Turn the intelligent tester main switch on.

    4. Select the menu items: Powertrain / Engine and ECT / Data List / Accelerator Pos No.1, Accelerator Pos No.2.

    5. When depressing or releasing the accelerator pedal, check that the values of the accelerator pos No.1 and accelerator pos No.2 are within the specification.

      Accelerator Pos No.1 standard voltage:
      Condition
      Specified Condition
      Accelerator pedal is released
      0.4 to 1.4 V
      Accelerator pedal is depressed
      3.0 to 4.6 V

      Accelerator Pos No.2 standard voltage:
      Condition
      Specified Condition
      Accelerator pedal is released
      0.9 to 2.3 V
      Accelerator pedal is depressed
      3.4 to 5.5 V

      If the result is not as specified, check the accelerator pedal, wire harness and ECM.