Home › RESTRAINTS › SEAT BELT › OCCUPANT DETECTION SENSOR

OCCUPANT DETECTION SENSOR > INSPECTION

for Preparation Click here



1. INSPECT SEPARATE TYPE FRONT SEAT CUSHION PAD


    B112701E05
  1. Disconnect the separate type front seat cushion pad connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Seat belt is unfastened, front passenger seat occupied
    Below 100 Ω
    1 - 2
    Seat belt is unfastened, front passenger seat not occupied
    Below 1 MΩ