FRONT SEAT INNER BELT ASSEMBLY > INSPECTION |
| 1. INSPECT FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE) |
![]() |
Disconnect the front seat inner belt assembly.
Measure the resistance when the switch is operated according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Seat belt is fastened | 10 kΩ or higher |
| 1 - 2 | Seat belt is unfastened | Below 1 Ω |
| 2. INSPECT FRONT SEAT INNER BELT ASSEMBLY (FRONT PASSENGER SIDE) |
![]() |
Disconnect the front seat inner belt assembly.
Measure the resistance when the switch is operated according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Seat belt is fastened | 10 kΩ or higher |
| 1 - 2 | Seat belt is unfastened, front passenger seat occupied | Below 100 MΩ |