ELECTRONIC CONTROLLED AUTOMATIC TRANSMISSION SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC (using an intelligent tester) |
![]() |
DTCs which are stored in the ECM can be displayed with the Intelligent Tester and generic OBD scan tool.
These scan tools can display pending DTCs and current DTCs. Some DTC aren't stored if the ECM doesn't detect a malfunction during consecutive driving. However, the detected malfunction during once driving is stored as pending DTC.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the intelligent tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Check and make a note of DTCs and freeze frame data.
Confirm the details of the DTCs (Click here).
| CLEAR DTCS AND FREEZE FRAME DATA (using intelligent tester) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON (do not start the engine) and turn the intelligent tester ON.
Enter the following menus: Powertrain / Engine and ECT ECT / DTC / Clear.
Erase DTCs and freeze frame data by pressing YES on the tester.
Turn off the ignition and then turn it on again, and check that the monitor is not displaying any DTCs.
If any DTCs are displayed, repeat from step (c).
| CLEAR DTCS AND FREEZE FRAME DATA (without using intelligent tester) |
Perform either one of the following operations.
Disconnect the battery negative (-) cable for more than 1 minute.
Remove the EFI fuses from the engine room R/B for 1 minute or more.
However, if you disconnect the battery terminal, perform the "INITIALIZE " procedure.