ELECTRONIC CONTROLLED AUTOMATIC TRANSMISSION SYSTEM > HYDRAULIC TEST |
| PERFORM HYDRAULIC TEST |
Measure the line pressure.
![]() |
Warm up the ATF (Automatic Transmission Fluid).
Lift the vehicle up.
Remove the test plug on the transmission case front left side and connect SST.
Fully apply the parking brake and chock the 4 wheels.
Start the engine and check idling speed.
Keep your left foot pressing firmly on the brake pedal and shift into the D position.
Measure the line pressure when the engine is idling.
Depress the accelerator pedal all the way down. Quickly read the highest line pressure when engine speed reaches stall speed.
In the same manner, do the test in the R position.
| Condition | D position kPa (kgf / cm2, psi) | R position kPa (kgf / cm2, psi) |
| Idling | 377 to 436 kPa (3.8 to 4.4 kgf/cm2, 55 to 63 psi) | 536 to 634 kPa (5.5 to 6.5 kgf/cm2, 78 to 92 psi) |
| Stall test | 1,043 to 1,165 kPa (10.6 to 11.9 kgf/cm2, 151 to 169 psi) | 1,294 to 1,569 kPa (13.2 to 16.0 kgf/cm2, 188 to 228 psi) |
| Problem | Possible cause |
| Measured values are higher than specified in all positions |
|
| Measured values are lower than specified in all positions |
|
| Pressure is low in the D position only |
|
| Pressure is low in the R position only |
|