DTC P0756 Shift Solenoid "B" Performance (Shift Solenoid Valve S2) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0756 | The gear required by the ECM does not match the actual gear when driving (1-trip detection logic) |
|
| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0756) |
Connect the Intelligent Tester to the DLC3.
Turn the ignition switch to the ON position.
Turn on the tester.
Select the item "Power train / Engine and ECT / DTC / Current or Pending".
Read the DTCs using the Intelligent Tester.
| Display (DTC output) | Proceed to |
| Only "P0756" is output | A |
| "P0756" and other DTCs | B |
|
| ||||
| A | |
| 2.INSPECT SHIFT SOLENOID VALVE S2 |
![]() |
Remove the shift solenoid valve S2.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition 20°C (68°F) |
| Solenoid Connector (S2) - Solenoid Body (S2) | 11 to 15 Ω |
Connect the positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body.
|
| ||||
| OK | |
| 3.INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
|
| ||||
| OK | ||
| ||