Home › BODY ELECTRICAL › DOOR LOCK › KEY REMINDER WARNING SYSTEM

KEY REMINDER WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



B112422E01


COMBINATION METER
  1. Disconnect the H20 meter connector.

  2. Measure the voltage and resistance of the wire harness side connector.


Standard: 
Symbols (Terminal No.)
Wiring Color
Terminals Description
Condition
Specified Condition
IG+ (H20-6) - Body ground
B-R - Body ground
Ignition switch (IG) signal
Ignition switch OFF → ON
Below 1 V → 10 to 14 V
B (H20-5) - Body ground
R - Body ground
+B power supply
Always
10 to 14 V
KSW (H20-11) - Body ground
Y - Body ground
Key unlock warning switch input
No key in ignition key cylinder → key inserted
10 kΩ or higher → Below 1 Ω
SW (H20-12) - Body ground
B - Body ground
Front door courtesy light switch (Driver side) input
Front driver side door CLOSED → OPEN
10 kΩ or higher → Below 1 Ω
E1 (H20-7) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
If the result is not as specified, there may be a malfunction on the wire harness side.